Brandtech-scientific Macro Transferpettor Manual de usuario Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 28
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
– 16 –
Kolbenstange wechseln
Alte Kolbenstange entfernen
Achtung!
Den kontaminierten Bereich von Cap und Seal nicht
berühren. Schutzhand schuhe benutzen.
Attention!
Do not touch the contaminated area of the tip
(= Transferpettor-cap) and the seal. Wear protec-
tive gloves.
- Cap abziehen.
"Cap wechseln", Seite 12.
- Pipettierknopf bis zum Anschlag
drücken.
- Kolbenstangensicherung gegen den
Uhrzeigersinn drehen. Dabei wird die
Kolbenstange aus dem Gerät ge-
schraubt.
- Kolbenstangensicherung von Kolben-
stange schrauben.
Changing the Piston Rod
Removing the old piston rod
- Remove the tip (= Transferpettor-cap).
"Changing the Tip", page 12.
- Push the pipetting key fully down.
- Turn the piston rod locking device
anticlockwise to unscrew the piston rod
from the instrument.
- Disconnect the piston rod locking device
from the piston rod.
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comentarios a estos manuales

Sin comentarios